The Nissan 200SX was a revolutionary vehicle when it was first produced. A small, light vehicle with a small displacement, moderately powerful engine, it has always been considered a driving enthusiast’s car since its introduction in 1974. The modern vehicles bearing this designation retain this same, basic formula.

Part of what makes this car such a blast to drive is its brakes. The single piston Nissan 200SX caliper is more than adequate for enthusiastic or panicked deceleration.

The modern caliper is mated to vented disk brakes, which is a similar technology to those used on racing cars. Proper functioning of the Nissan 200SX brake caliper is critical to safe and spirited driving. Brakes should be regularly inspected, especially for older models. Calipers are hydraulic driven clamps, essentially, which squeeze the brake pads against the disks, slowing the car. Rubber O-rings allow the pistons to move within the body of the caliper, and they can wear and break down over time. Dragging brakes are a symptom of this deterioration. While caliper rebuilt kits are available, a simpler option is to replace the entire caliper. Replacing the caliper is only adds two steps to replacing the brake rotor, physically screwing the brake hose into the new caliper and properly bleeding the brakes. If you are looking for more stopping power, you can consider a multi-piston Nissan 200SX brake caliper upgrade. While this can be an expensive proposition, the larger brake calipers mated to larger disks will offer eyeball popping stopping power, which you may need if you autocross or compete with your Nissan in some other capacity.Order replacement or upgrades Nissan 200SX brake calipers today from our online parts catalogue, because if you want to go, eventually you are going to have to stop!